Anyone have good pictures of the rear window area on 68-70 chargers...

[AdamMopar]

I've got to fabricate the last two pieces for my rear window and need some good pictures to see where the areas blend together.  Any close up shots would be appreciated.  Thanks, Adam

[70charginglizard]

These are the best ones I have.

These were taken just before I put my back window glass back in after all my body work on the roof was done.

Sorry about the quality but these are the best ones that I have.

[70charginglizard]

last one

[THE COLONEL]

I hope this helps you Adam.   Good luck!

[AdamMopar]

That will work perfect guys.     I appreciate the help.  Adam

[AdamMopar]

Definately going to be a tough area to blend together.  Looks like towards the top it just comes straight down from the sail panel and make a 90 degree angle, then towards the bottom it curves and makes a short drop down to the window flange.  Thanks again guys.  Adam

[THE COLONEL]

Glad we could help!

[70charginglizard]

you know Adam,
There are companies out there that reproduce the inner sail panel and the deck panel.
I believe you can get them from http://www.chargerspecialties.com
Thats where I got mine.
good luck

[AdamMopar]

Thanks, I did buy the rear deck filler panel so I have the lower channel.  I had to modify it slightly as it did not fit properly.  So I have the lower channel.  I also purchased the upper channel but it did not fit at all.  So I'm making my own.  also the side channels.

I forgot about the inner sail panels being reproduced.  I may have to think about that.  Thanks, Adam

[rebby]

I have a number of various pictures of this area on my body restoration page on my website. They are all 5.1 megapixel which might help...

http://charger.rebby.com/exterior.php?subpage=body

Look through all of the various months and you'll bound to find quite a few.

[AdamMopar]

Thanks I found some in there as well. Nice pictures.  Thanks again.  Adam

[bigroge1]

you know Adam,
There are companies out there that reproduce the inner sail panel and the deck panel.
I believe you can get them from http://www.chargerspecialties.com
Thats where I got mine.
good luck

holy crap.....u ended two weeks of searching for these parts....ur f&#kin awesome 

[Todd Wilson]

[AutoRust]

This might help some
its a 68 charger we did a lot of work on, including the rear window area.

http://autorust.com/gj1.html

dave

[69bronzeT5]

hope this pic helps. Cheers, Cody

[AdamMopar]

Didn't even know this thread was still alive.  I actually mocked up some pieces for the back window this past weekend.  I still have to adjust them a bit before they are ready to weld in.

Kind of sad I'm still at the same point I was over two years ago.   

Thanks for the pictures.

Adam