News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Rear window inside trim question

Started by Puzbie, November 06, 2022, 09:05:35 PM

Previous topic - Next topic

Puzbie

So I tried to install my aftermarket rear window inside trim and there is about a 2 inch overlap at the top center section where the connector goes (I think?)

Has anyone else run into this? its been 25 years since I took it off so the memory is a little short  :shruggy:

Just hoping it is expected and I need to trim it, but wanted to make sure I am doing it right. Thanks...

Charger_Fan

Photos may help.
So far I'm not sure which area you are talking about.

The Aquamax...yes, this bike spent 2 nights underwater one weekend. (Not my doing), but it gained the name, and has since become pseudo-famous. :)

Puzbie

good point it was clear in my mind  :icon_smile_big:


will

Did you tap the corners all the way in? Mine is exactly the same and I haven't gotten to it yet. I'm going to say try tapping it into the corners some more. If it doesn't go then trim the ends so they fit. Make sure the seam is centered.