Hello, can anybody give me measurements/location on where to drill the holes for the "Charger" emblem that goes on the sail panel on a non-vinal top 69? Both passenger and driver side? My car had the holes filled in so I have no clue on where exactly to mount the emblem. Thank you.
I think it would be easier to locate the holes from the inside. This pic is the drivers side, with wire stuck thru the holes.
I used 1 inch graph paper and started from the edge of the quarter and against the aft most point of the rear side window. I hope this helps. These are the original holes for the Charger emblems with a vinyl top. Somebody can chime in, but I believe they are the same with or without a vinyl top.
Pat
(https://s20.postimg.org/o8k0qfwcd/IMG_9185.jpg) (https://postimg.org/image/mtig1pv95/)
(https://s20.postimg.org/y4l3q324d/IMG_9174.jpg) (https://postimg.org/image/3n58yjerd/)
(https://s20.postimg.org/fnqoz9m65/IMG_9179.jpg) (https://postimg.org/image/pxt3yic1l/)
Measurements for the driver side
(https://s20.postimg.org/izozskdx9/IMG_9183.jpg) (https://postimg.org/image/7nceas589/)
P.m. me your address if you would like templates?
Thanks guys for pics! Really helped me out a lot. :2thumbs:
:2thumbs: wow, that was a really good idea!
this should be stickied with the trim holes.
Quote from: keepat on September 02, 2017, 01:03:56 PM
I used 1 inch graph paper and started from the edge of the quarter and against the aft most point of the rear side window. I hope this helps. These are the original holes for the Charger emblems with a vinyl top. Somebody can chime in, but I believe they are the same with or without a vinyl top.
Pat
(https://s20.postimg.org/o8k0qfwcd/IMG_9185.jpg) (https://postimg.org/image/mtig1pv95/)
(https://s20.postimg.org/y4l3q324d/IMG_9174.jpg) (https://postimg.org/image/3n58yjerd/)
(https://s20.postimg.org/fnqoz9m65/IMG_9179.jpg) (https://postimg.org/image/pxt3yic1l/)
Measurements for the driver side
(https://s20.postimg.org/izozskdx9/IMG_9183.jpg) (https://postimg.org/image/7nceas589/)
P.m. me your address if you would like templates?
I sent you a PM, could use a set for my NOS quarters. Thanks!!!
Excellento pipeliner ! :cheers: