Hello, I looked & looked with the search function & to no avail, what is the width and depth of a Daytona,Superbird front spoiler ?
Thanks
Charlie
Quote from: cdr on July 09, 2020, 11:42:30 AM
Hello, I looked & looked with the search function & to no avail, what is the width and depth of a Daytona,Superbird front spoiler ?
Thanks
Charlie
Charlie... I have a spare spoiler I can take some measurements from and then there's the one on my Daytona...
Troy
Quote from: hemi68charger on July 09, 2020, 11:56:41 AM
Quote from: cdr on July 09, 2020, 11:42:30 AM
Hello, I looked & looked with the search function & to no avail, what is the width and depth of a Daytona,Superbird front spoiler ?
Thanks
Charlie
Charlie... I have a spare spoiler I can take some measurements from and then there's the one on my Daytona...
Troy
That would be AWESOME :) thank you Troy, there is some Skunk works going on with my Charger :)
Here's a good design for a Charger.
Birds and Daytonas required a different shape. :Twocents:
Quote from: odcics2 on July 09, 2020, 12:41:25 PM
Here's a good design for a Charger.
Birds and Daytonas required a different shape. :Twocents:
I appreciate that, I was wanting to get rid of the camaro one that I have now, & use the Daytona one on the 68 front end for now & then when I get a Daytona nose & would already have the spoiler. looking at the one from Perfomance Car Graphics , the +2 in depth. I ordered a Daytona wing from Dane & have the trunk braces already, thanks again. this will be a SLOW CLONE build lol.
Ummm is the hole in your hood getting bigger ?
Quote from: 70 sublime on July 09, 2020, 02:23:22 PM
Ummm is the hole in your hood getting bigger ?
if it gets any bigger it will be GONE LOL :)
OOOPPS I corrected my misspelling of Spoiler LOL
My original Superbird spoiler that's been taken off and laying flat, measured 51-1/2" tip to tip.
Measuring the amount that stick outward from the nose, from the inside of the bend, was 3-1/4".
Jay
Quote from: PettyMower on July 10, 2020, 08:29:59 PM
My original Superbird spoiler that's been taken off and laying flat, measured 51-1/2" tip to tip.
Measuring the amount that stick outward from the nose, from the inside of the bend, was 3-1/4".
Jay
Thank you Jay !!!
I am now in the Wing car club,,, well,,,,,,,,,,,almost 🙂 Got the Daytona ALUMINUM wing mocked up, holes drilled, got the wing washers in,,, paint tomorrow for the wing and then install, thank you Dane Gjesdal
for coming up with these wings, and your son Justin Gjesdal
did a very nice job on this wing, it's like Christmas for me
Still got to finish the trunk braces but got everything pretty much mocked up, the charger is now a wing car.
2
The word that comes to mind is: Excellent :2thumbs: Most Excellent.
Make sure you get a picture of it in the door mirror will make it feel so much more real :2thumbs:
Nice Charlie !
Thank you guys, took the car out to get some fuel, it was a nice drive, the wing gets way more attention than I thought it would.
2
Looks good :2thumbs: :2thumbs:
:2thumbs: