Does anyone have the dimensions of the 3 different size spacer blocks that are used in mounting the turn signal housings to the z-brace brackets on a Daytona?
Maybe someone repos them 3 aluminum blocks with a hole
Good day sir,
I received this information from hemigeno:
> Each spacer is constructed from solid aluminum, approximately 1/2" x 1/2" square
> The top spacer thickness was 1/8"
> The middle spacer thickness was 3/16"
> The bottom spacer thickness was 3/8"
> The screws were a 1/4" hex washer head, with slot
Hope this helps.
Curt
"Hope this helps.
Curt"
It certainly does, thanks.
Cy
Pictures
Thanks Dave.
Quote from: nascarxx29 on October 23, 2022, 08:03:44 PM
Pictures nascarxx29
Hi nascarxx29, 25 October 2022
That's a nice looking Daytona Nose Cone. It's either a restored Creative Cone, a factory new or an Aftermarket. Sure looks nice from the photos. Could be a fourth option but can't think what that would be.
Best Always
426 Hemi Chicks
Gene Lewis AKA Hemi Genos restoration thread .Restored by Vance Cummings Michigan
http://www.dodgecharger.com/forum/index.php/topic,48725.0.html