I'm looking for a tubing bender and would like to know if anyone has one, how they like it and where they bought it. I honestly don't want to spend more than $500 or so unless I am completely convinced that this is the bender. Any info would be great.
Exhaust , roll bars ???? we used a stand up version for roll bars bolted to the floor on a pedestal & you pushed or pulled on a 6' lever , it did great bends & was accurate , I can probably get the make of it , it used to be advertised in Mags
Tube fenders and a roll cage. From what I founf most decent benders sell seperate from dies which run another $180 and that is only one set, so I would have to use the same dia. tube for everything or spend mega bucks on dies.
BTW it isn't for the Charger, really.