Looking to replace the studs in my 8.75 rear and Summit has ARP 100-7705 with a 680 knurl which says its for Chrysler rear brake applications which seems large doesn't it ?
Check these out, I would measure yours but should be ok.
http://www.ebay.com/itm/250975400845?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Thanks, I'll have to get a caliper and check them. I stuck a 615 stud in it and it "almost" fit.
Quote from: 68 RT on August 21, 2015, 12:11:28 PM
Check these out, I would measure yours but should be ok.
http://www.ebay.com/itm/250975400845?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Is the number 685 is that (thousandths) ?
I believe the use of those .680"-.685" knurls is predicated on wallowed out stud holes, might be too big for the standard holes which, I believe, are closer to .665".