The stainless trim that goes around the sail panel vinyl has screws that go into the trunk area. Which nuts are used inside the trunk. My car was apart when I go it so don't have a clue
I found a 8 32 hex nut that works or PAL nuts (both in the picture.) So what's correct? The screw is a 8 32 machine bolt.
Hi Mitch
I will probably ask you the same question when I get to putting on my trim.
Getting close.
I bought my car new and took it apart myself 5-10 years ago.
So I have no excuses!
John
I think I'm going with the PAL nuts. I can put sealer in the cups of the nuts plus I can't get as much torque on the PAL nuts before they strip. A lot of torque with the machined hex nuts might distort the outside sheet metal.