DodgeCharger.com Forum

Mopar Garage => General Q&A => Topic started by: 41husk on February 06, 2017, 02:33:21 PM

Title: tech Decal location
Post by: 41husk on February 06, 2017, 02:33:21 PM
I have some decals that came in a Phoenix graphics kit.  I called Phoenix graphics and they apparently don't know where there decals go.
1. Jacking instructions for sure grip Differential.   It is a white with red print decal.  I have read that they are only on 62-67 cars.  I have heard that they went on the inside of the glove box door, and on the inside of the deck lid near the jack.

2 Vehicle manufactured following all United states safety standards  This is a black decal. 

3. Warning disconnect regulator before servicing  This is a small red tab looks like it is held down with a screw.  It is not adhesive.

4. Tire pressure  I know this goes on the driver side door jamb, but not sure exactly were.

Any pictures or info would be greatly appreciated.   Thanks!

Title: Re: tech Decal location
Post by: birdsandbees on February 06, 2017, 04:57:13 PM
Here's the standards sticker spot.... see the sticker under my '89 paint job  :brickwall: .. above the jam switch location  
Faces to read from the drivers seat.
Title: Re: tech Decal location
Post by: birdsandbees on February 06, 2017, 05:03:48 PM
Air Pressure on my '70 Bird... imagine the '69 went in the same place, but hopefully someone can confirm.
Title: Re: tech Decal location
Post by: tan top on February 06, 2017, 05:30:20 PM
 :yesnod:

these are from a 69 charger

jack instructions are what I have found on unrestored original chargers , not saying there are no variations  never say never etc

A location   1968 & 1969  Hamtramck cars
B  location   1968 & 1969 & 1970  St Louis  cars
C  location  1970 St Louis cars

  the sure grip decal , have seen them inside the trunk lid  ,  not sure if it was the original location  , also see / heard in the glove box  stuck to the side or on the fuse box door ,  also stuck to the owners manual /warranty booklet  plastic wallet  :shruggy:  ....... :popcrn:

think from memory the red triangularish   red alternator label is actually attached by the green field wire male spade connector  , sort of clamped between it , so when the field wire is connected you cant see it  , or just the edges  :scratchchin: , I await to be corrected on any of these  :yesnod: :2thumbs: :cheers:
Title: Re: tech Decal location
Post by: 41husk on February 07, 2017, 08:34:22 AM
Thanks guys.  That will do it!! :cheers: :cheers: :cheers: