Would anyone be willing to get measurements/ pic of where the z bar mounts to the driver side frame? Thanks
Assuming this is for a 2nd gen., see this post 3/4 of the way down. I used the notch on top of the frame rail and the inside corner of the mount, to align mine. Like in the picture with an arrow drawn on it showing where. I also put the trans with bellhousing in, just to make sure the z-bar was straight. Some aftermarket mounts have a tab for 3rd gens, that you'll need to grind off. I read the slot for that tab, may possibly exist on some late 70 cars. Good luck on your conversion!
http://www.dodgecharger.com/forum/index.php/topic,95764.25.html (http://www.dodgecharger.com/forum/index.php/topic,95764.25.html)
Thank you!