My 68 has been apart since before dirt and rebuilding is under way. Now I got a set of new AMD valance corners which have a tail on the bottom of them. Does the tail weld between the trunk floor extension and the quarter or does it weld to the bottom of the quarter ? thanks..
Al. I believe I tucked the tail in between. I'll check tomorrow. If your building a nice driver like I did I wasn't to concerned
I'm pretty sure they weld to the bottom of the quarter. I found a reference pic somewhere I'll see what I can find.
anyone have an answer for this?
Here's a pic of my Factory Original Corner. LEON.
So based on your pic the tail should go between the trunk extension and quarter panel.
I guess that makes scene in the fact that water would would not get trapped
Quote from: NHCharger on October 05, 2018, 09:01:40 PM
Al. I believe I tucked the tail in between. I'll check tomorrow. If your building a nice driver like I did I wasn't to concerned
Hey Brian, ya same here. When I had it mocked up it looked like it would go between the quarter and the ext. and i doubt anyone would want to check.
Heres an original on a 1970 Hemi Charger.