i built this engine although its not in the car yet.643 hp at 5600rpm. and 676 tq at 3700 ? i believe.10.0 compression 4.50 stroke and .055 overbore.i used edelbrock victor heads with harland sharp rockers.an MP. dominator intake with a pro systems sv-1 single barrel carb
also used a bullet solid roller cam..622 lift duration was 261,263 @ .050
:2thumbs: would love to see that dyno run ,
Have built similar but with victor top end
I would think that combo should make more power and especially more torque. can you post the dyno sheet?
i can post that but i dont have it here.it might could make more power with more compression, its actually fairly tame
you can watch the dyno run on youtube if you like..search for " 541 dodge d trent.".should go right to it
Quote from: red69superbee on December 04, 2014, 11:56:28 PM
i built this engine although its not in the car yet.643 hp at 5600rpm. and 676 tq at 3700 ? i believe.10.0 compression 4.50 stroke and .055 overbore.i used edelbrock victor heads with harland sharp rockers.an MP. dominator intake with a pro systems sv-1 single barrel carb
Very Nice Engine :2thumbs:
and,
with a relatively easy Camshaft, good job !
:yesnod: :2thumbs: :coolgleamA:
https://www.youtube.com/watch?v=dvsF_LTTW9I