hi guys,
i got the car back from the builder and noticed the breather valve cap is loose. Talked to the guy and he said to put in a thicker gasket. i looked at it and it seems/looks to me it does have one tan colored gasket. i looked it up on summit and classic industries and only think i can find what seems like thick plastic/rubber looking gasket. is that what i would need? Sorry guys newbie question and dont want to screw up the motor
Factory style valve covers ?
You can use a thicker gasket or just double-up on the original gasket. Cut one out of sheet gasket material.
Quote from: 70 sublime on July 06, 2020, 11:08:24 AM
Factory style valve covers ?
Mopar valve covers from summit. The breather cover is also mopar was supplied by the builder.
Can you post a picture? What year?
I had an issue like that and noticed there was a bent 'spring' washer that worked with the gasket. I bent it more and it now holds my breather in place without being loose.
I wonder if you have the same thing. The spring thing is under the gasket in the picture.
I also have the push in type and I can look that up, It is a rubber gasket though.
Quote from: Mopar Nut on July 06, 2020, 02:46:45 PM
Can you post a picture? What year?
It's a 70 charger.
This is the ring I bent I am using aftermarket valve covers so maybe what is needed in your case is different.
Quote from: XH29N0G on July 07, 2020, 07:20:02 AM
This is the ring I bent I am using aftermarket valve covers so maybe what is needed in your case is different.
thanks!! will try that out!