What is the correct socket for the RMS cap bolt on a 440? It's not a standard hex head. It looks like a Torx head but none of my torx sockets fit it. I have a spline socket set that goes down to 3/8" but that doesn't fit either. 5/16" spline?
Thanks
Curt
12 points star 3/8"
http://store.440source.com/Rear-Seal-Cap-Bolts-Set-of-2-New/productinfo/109%2D1501/
Thanks Nacho. A 12 point star, that's not the same as a "spline" socket?
Dunno, I just posted how I know it and 440source call it the same
I believe they are the same. My 3/8" spline socket wouldn't fit in the recess those bolts are sunk into. So I took it to the grinder and made a thin-walled socket out of it. That did the trick. They seemed to fit the bolt OK and I managed to get both out without stripping them.
I just use a 12 point 3/8" socket