Hey Gang...
I'm in the beginning stages of the restoration of my '69 Hemi Charger 500, disassembly.. I have noticed that previous owners have been inside the doors to "fix" the power window system, but hacked it up.........There seems to be a support bracket or two missing? Does anyone have door pictures with the regulator system still installed with the door panels off? Think there is a support bracket missing at the bottom of the regulator assembly between the assembly and the bottom of the door sheetmetal, down by the secure clip holes for the door panel.. Should be pretty much the same thing for any '69 B-body..
Cheers,
Troy
http://www.dodgecharger.com/forum/index.php/topic,91429.0.html
http://www.dodgecharger.com/forum/index.php/topic,55065.0.html
From older post do you need factory picts and part number and views. I have full dealer catalogs on cds
Hey Dave.. Thanks.. Really in need for the doors.. But factory drawings would be cool too..
Turns out I still have the original cluster in the 500. Seems all a previous owner did was lay a 69 SE woodgrain overlay over it with screws and a washers to hold it in place. So, that's good. Question is the apparent "circuit breaker?" that is attached to the amp gauge with a thick red gauged wire attached to it. I am assuming it is for the power window circuit since this is different than all the manual window cars I have owned.
Yes it is.
Here is about one picture I just found online in an ebay ad.. At the very bottom, you see the power motor with a bracket attached to it and I'm assuming the other end is attached to the door shell just below it...