my voltage regulator blew out. i put a new electronic one on and now my gauge does not read positive, once the motor starts it reads neg. and if i use any acc. it goes further neg. i had the alternator checked and its good. if i give it some gas the needle just stays where it is, it doesnt go to charge ever. i cant figure out whats wrong.
need some help here guys :brickwall:
Does the fusible link have anything to do with the charging circuit? You can run the engine and then jump a wire from the two ends of the link wire and see if it starts charging? Lets see how long it takes for your thread to be " moved " to the electrical section. They really enjoy doing that. :yesnod:
make sure there is a good clean ground to the firewall- no paint behind the reg. or the spot for the bolt!!!
problem solved, that new voltage regulator i bought was bad,i got another one and its fine.
thanks guys