Text only | Text with Images

DodgeCharger.com Forum

Mopar Garage => Chassis, Suspension, Brakes, Wheels, & Tires => Topic started by: john108 on April 15, 2020, 01:03:35 PM

Title: Which way does this go in
Post by: john108 on April 15, 2020, 01:03:35 PM
1968 Charger
Tank Fill Line Seal.
Service Manual Picture TOO Small to see.

In the picture, Is it pointing in the right direction??
Title: Re: Which way does this go in
Post by: john108 on April 15, 2020, 01:08:01 PM
I Found an Example.  I believe it is shown Correct.
Thank You.

Now How to lube and squish it in. Going out to try now.

DONE - Easier than I thought.

I Hope my Pictures Helps someone.
John
Title: Re: Which way does this go in
Post by: John_Kunkel on April 16, 2020, 01:46:22 PM
K-Y Jelly is an excellent lubricant for assembling rubber parts. Silicone grease works well, too.
Title: Re: Which way does this go in
Post by: Charger-Bodie on April 16, 2020, 02:47:01 PM
solvent based wax and grease remover is the best lube for rubber.
Title: Re: Which way does this go in
Post by: Bronzedodge on April 17, 2020, 07:48:20 PM
That seal look odd - asymetrical to the original ones I have here.  Never seen the bulge on the left of the pic.  It looks a bit rough too - cracks in the groove?  that being said, the new one I had here was really stiff vs the original one out of the tank, to the point that I had gloves on and in the trunk, pushing hard and I'm not a skinny guy.  I ended up using my original.     :Twocents:
Text only | Text with Images