hi guys
does anyone have a measurement of where the bolt goes in the trunk, that holds the jack down . Rene
Chris (Daytona RT / SE) was discussing his jack hold down bolt's mockup in this thread:
http://www.dodgecharger.com/forum/index.php/topic,32792.0.html
I think Chris used the dimensions from my original bolt's location, and it didn't work (sorry again, Chris!)
About 11-3/4" or so from the corner of the trunk extension would work better than the 11" shown in the picture below. The second picture's dimension of 11" should work fine though.
thank you Gene , thats exactly what i needed . Rene
Quote from: hemigeno on August 28, 2008, 07:26:26 PM
Chris (Daytona RT / SE) was discussing his jack hold down bolt's mockup in this thread:
http://www.dodgecharger.com/forum/index.php/topic,32792.0.html
I think Chris used the dimensions from my original bolt's location, and it didn't work (sorry again, Chris!)
About 11-3/4" or so from the corner of the trunk extension would work better than the 11" shown in the picture below. The second picture's dimension of 11" should work fine though.
That reminds me....I still need to weld that "extra" hole up ;) :nana: :smilielol:
Quote from: Daytona R/T SE on August 28, 2008, 11:23:12 PM
Quote from: hemigeno on August 28, 2008, 07:26:26 PM
Chris (Daytona RT / SE) was discussing his jack hold down bolt's mockup in this thread:
http://www.dodgecharger.com/forum/index.php/topic,32792.0.html
I think Chris used the dimensions from my original bolt's location, and it didn't work (sorry again, Chris!)
About 11-3/4" or so from the corner of the trunk extension would work better than the 11" shown in the picture below. The second picture's dimension of 11" should work fine though.
That reminds me....I still need to weld that "extra" hole up ;) :nana: :smilielol:
thanks for the lesson learned :hah: :smilielol: