Today I was putting on a new replacement fuseable link wire that I had fried a month or so ago, and after inserting it back into the harness block and attaching it to the firewall, I noticed that the bottom connector was loose to the fuse block on firewall, so I snapped it back into place, but found one wire that wasn't connected to anything, has a plastic connector on one end, wire appears to be yellow, any ideas what this is supposed to attach to? I'm pretty sure there was no loose connections before I started messing with these engine compartment wires.
Thanks,
Lord Warlock
This one?
that's the only yellow wire that I was thinking of as well...goes to starter relay...
(dan that engine compartment is clean...come do mine?)
that looks like it should be the right one, now I'll look at it tomorrow and see if I can connect it. May decide to verify the connections first though. Thanks for the picture, it will help.
Looks correct, the yellow wire goes to the "I" terminal which is next to the "G" terminal that gets the brown wire.