DodgeCharger.com Forum
June 19, 2019, 11:04:02 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: DodgeCharger.com decals are available here!
 
   Home   Help Calendar Login Register Chat  
Pages: 1 [2]  All   Go Down
  Print  
Author Topic: Help from clonies...please?  (Read 3367 times)
wetfeetmi
Full Member
***
Offline Offline

Posts: 274


« Reply #25 on: March 23, 2006, 01:42:21 PM »

Thanks, Howie...I will not be needing it, though! I made due with my original tracing and finished the hinges. I had to piece them together as well as possible. The hinges came out pretty close with a little tweaking.
 I still need pinpoint measurements to spot the wing. I know you don't have them because you have a 500, but if anyone else could take a minute and pass those to me, I would be greatly appreciative. Thanks, Rick
Logged
hemigeno
Global Moderator
Old Timer
*****
Offline Offline

Posts: 6,387



« Reply #26 on: March 23, 2006, 02:45:39 PM »

Thanks, Howie...I will not be needing it, though! I made due with my original tracing and finished the hinges. I had to piece them together as well as possible. The hinges came out pretty close with a little tweaking.
 I still need pinpoint measurements to spot the wing. I know you don't have them because you have a 500, but if anyone else could take a minute and pass those to me, I would be greatly appreciative. Thanks, Rick

Rick, what kind of pinpoint measurements are you looking for?  I can measure from the end of the quarterpanel extension to the very tip of the wing base, if that would help   shruggy

Let me know, and I'll do what I can to help out!

Logged
hemigeno
Global Moderator
Old Timer
*****
Offline Offline

Posts: 6,387



« Reply #27 on: March 23, 2006, 02:59:49 PM »

Ok, I dunno if this is what you're looking for, but I measured from the end of the quarterpanel (with the extensions installed) and came up with approximately 3" between the end of the quarterpanel and the rearmost tip of the vertical stabilizer.

I say approximately, since the wing that Creative Industries installed on my car is 1/4" different from one side to the other.

The passenger's side is just a shade less than 3", and the driver's side is 3-1/4".  So much for precision installation techniques... smash

Hope this helps,

Geno
Logged
wetfeetmi
Full Member
***
Offline Offline

Posts: 274


« Reply #28 on: March 24, 2006, 03:18:52 PM »

Thanks, hemigeno! I wil split the difference and drill some holes. Take care, Rick
Logged
Pages: 1 [2]  All   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!
Page created in 0.042 seconds with 16 queries.