News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Ron francis wiring questions

Started by frank1966, December 29, 2015, 11:01:47 PM

Previous topic - Next topic

frank1966

Hello all,

iam putting in the RF 24 7

1. the original harness for the wiper pump has about 3-4 wires coming out of the old bulkhead going to the pump. RF kit has one wire for wipers?

2. the air conditioning unit in the engine bay near the firewall has also 3-4 wires attached to the same bulk head connector as the wiper motor.

I don't see how to hook up these components to the RF kit?

Rolling_Thunder

The wires you have should be used to power the wiper switch as well as the washer pump.

Your original wiper switch will need to be powered by the Ron Francis wire...    it should connect on the two posts that are circled in Yellow

Run a jumper from the orange circled post to the washer button on the washer button.

1968 Dodge Charger - 6.1L Hemi / 6-speed / 3.55 Sure Grip

2013 Dodge Challenger R/T - 5.7L Hemi / 6-speed / 3.73 Limited Slip

1964 Dodge Polara 500 - 440 / 4-speed / 3.91 Sure Grip

1973 Dodge Challenger Rallye - 340 / A-518 / 3.23 Sure Grip

frank1966

Thanks, so I need to power both from the single ron francis wire? The orange post? I don't get that, isn't the button on the front side of that post?