DodgeCharger.com Forum
May 24, 2019, 05:29:50 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Please remember: this is the place to discuss Chargers - NOT the place to discuss politics. Political posts will be locked or deleted at the Moderator's discretion.
 
   Home   Help Calendar Login Register Chat  
Pages: [1]   Go Down
  Print  
Author Topic: AC/Heater Ducting - 68 Charger  (Read 132 times)
john108
Senior Member
****
Offline Offline

Posts: 722


« on: March 27, 2019, 11:40:23 AM »

Hi
A long time has past since I took it apart.
I am getting ready to install the AC/Heater Ducting under the Dash.
 I had to get replacement after market flexible ducts.
They don't have the latches that the original had and also the transition from round to rectangular are now separate pieces.
The original flexible ducts may have attached to the rigid ducts with, I think, flattened "Z" shaped clips. 
I am concerned that trying to use that type of clip would rip the flexible ducts when trying to install.

If those clips are recommended, do you know of a source?

Would you still use them or use hose clamps?
Also, when attaching rigid plastic parts together, what do you use?  Those "Z" clips could have been installed easily here.
 I thought about drilling holes through both and installing a screw??
I hope this makes sense, if not, I can add pictures.
Thank You
John
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!
Page created in 0.039 seconds with 16 queries.