Car Craft 440: 527hp, 557 torque

[dwbiggs]

Very similar to my build:

440 =0.040 over
Ross forged
10.5:1 zero decked
Eddy 84cc heads
crane 1.5 RA
Eddy RPM manifold
Hughes 238/244, .536/.540 110LSA
Holley 750 VS (probably undersized)
1 7/8" TTI headers
15deg inti/35deg total
12 Hg vacuum

Built it with 500HP in mind but haven't actually dyno'd it.  Would be nice if it did though!

[10secBEE]

 dwbiggs, just curiuos how does that combo run? Do you have any porting done to the heads? That is almost identical to what I'm putting together and was just curious if your happy with the power? Thanks 

[pipeliner]

 

[Challenger340]

Gonna Dyno a Shop Engine sometime in the next coupla weeks, pretty similar stuff, I'll post up the results when done.
It's a bunch of parts we had laying around, figured we'd just do it as time permits(not), for resale at some point later, or, lend it out as a Spare if somebody needed it for a weekend,  now a Guy wants it, so it's Sold when Dyno'd
But,
In the meanwhile, here's the Basic Combo as per a "street friendly" pump gas Engine with small Cam.

440 .030" over
ICON Forged Flat Tops
Eagle Rods
Stock Forged Crank ground .010/.010
Eddy Performer RPM 84cc Heads, Street Ported W/Better Valve Grind & CompCams hardware.
Eddy Performer RPM Intake untouched
Holley 830 cfm 4150 HP Series Carb
Harland Sharp Rockers
CompCams XE284H Hydraulic Flat Tappet stick, 240/246 @ .050, .507"/ .510" Lift
Comp Ratio @ 10.4

Any GUESSES for the pool ? Closest gets bragging rights LOL !

Like I said, I will post up the Dyno Sheet from the SF902 Dyno when done.

[skip68]

I'll say about 525hp.

[Challenger340]

I'll say about 525hp.

And you would be Bang on ! with your estimate.

Dyno'd yesterday at 525hp @ 5400 rpm, and 551 Ft/Lbs Torque @ 3700 rpm.  Pretty nice running little non-Stroker .030 over 440.

I'll get the Dyno Sheet up here in a day or 2 if anybody's interested.

Just found a Sheet, gotta keep looking look for a full run...

[skip68]

Sweet!   Good work.