DodgeCharger.com decals are available here!
Started by mally69, October 08, 2008, 12:08:30 AM
Quote from: Musicman on October 20, 2008, 09:56:39 PMThere is a thread over at Moparts concerning this topic, in which Brandon pretty much tells it like it is.http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=4752924&page=0&fpart=1&vc=1
QuoteIn plain english, this means "If you're dumb enough to slap a bunch of parts together in a performance engine without checking anything, don't expect us to bail you out once it turns into a grenade."
QuoteClearanced for large diameter valve springs, our Stealth heads use factory type rocker arms and stock diameter shafts, so no special "high-dollar" offset rockers are required. Any rockers that work on a stock Mopar head will work on our heads. This includes roller rockers, or even stock type stamped steel rockers...
Quote from: Steve P. on October 25, 2008, 04:12:23 PMI don't exactly agree. Any and all high performance and aftermarket parts must be checked. As I said above, I came across MANY bad parts directly from the BIG THREE that were supposed to be factory replacement that had issues.. I think more of what you are reading is a company that is tired of being bashed for trying to do good.. I have heard the INDY stories from hell as well.. Is it different for them because they are INDY?? The Indy COMPLETE motor I am referring to was in the tens of thousands and is owned by a member here... How about a ARRUZZA HEMI?? Or the POS Eddy carbs?? Or the Eddy heads with tight guides??Here is a company selling a product that everyone building an can save a bunch of money and keep straight plugs and the look of an iron head. YES. Some problems have come up as do with 99% of new products. Could all of this been handled differently, MAYBE,, SURE.. Can these heads work for a huge amount of us YES... Mally points out the troubles with these heads. Many including Firefighter have gone over and over this. I would be pissed if I had these troubles too. I would be more pissed at ME for not double checking everything..... My
Quote from: dstryr on October 25, 2008, 04:45:32 PMIf a gasket does overhang in the chamber say 1/32" but not the cylinder bore is that still going to cause problems?
Page created in 0.308 seconds with 17 queries.