RB lift in place

[greenrt_se]

Best place to lift 440 back to engine room,Carb threat or from head(passanger front /driver back) head are edelbrock Aluminium
??

[Runner]

i like a lifting plate on the intake manifold carb mounting flange. 

[Chryco Psycho]

I usually use the 3/8" holes at the front & rear of the heads 

[rebby]

I usually use the 3/8" holes at the front & rear of the heads 

Ditto. It has worked very well for me in the past.

[firefighter3931]

If i'm pulling just the engine the carb flange plate works fine. When i do an engine-tranny pull i like to use a load leveller which has a 4 point attachment and makes things a lot simpler/easier. The load leveller allows you to adjust the angle while everything is still loaded on the crane. 

Ron