Small block with super comp Hooks

[charger_cody]

Is anyone running a small block with Hooker super comp headers? Did you have to run the drag link through the header?

Cody

[lisiecki1]

i ran 3 different sets of full-length headers on my old 360 and all 3 had the drag link through the drivers side header.  the added cost of an alignment was a little pita, but worth it.

[charger_cody]

i ran 3 different sets of full-length headers on my old 360 and all 3 had the drag link through the drivers side header.  the added cost of an alignment was a little pita, but worth it.

Thanks buddy!!!  That's all I needed to know.

Cody

[lisiecki1]

no problem, as far as i know all full length headers for small blocks in b bodies are the same way.

[69bronzeT5]

I have Hooker Comps in my Duster and it has a 318. Not too sure which suspension piece goes through the header (not too knowledgeable with suspension) but it's a bitch to get the header off that's for sure.

[NMike]

most important question, will you be able to install the left side rear header bolt in the car? the super craps i have in my car is almost impossible to install the last bolt, plus the 5/7 plugs are a huge bitch to get to also!

[charger_cody]

most important question, will you be able to install the left side rear header bolt in the car? the super craps i have in my car is almost impossible to install the last bolt, plus the 5/7 plugs are a huge bitch to get to also!

Mine did it just fine!!!! Is it just not meeting up with the hole?

Cody