541 cubic inch from 440 stock block

[red69superbee]

i built this engine although its not in the car yet.643 hp at 5600rpm. and 676 tq at 3700 ? i believe.10.0 compression  4.50 stroke and .055 overbore.i used edelbrock victor heads with harland sharp rockers.an MP. dominator intake with a pro systems sv-1 single barrel carb

[red69superbee]

also used a bullet solid roller cam..622 lift duration was 261,263 @ .050

[fy469rtse]

  would love to see that dyno run ,
Have built similar but with victor top end

[oldschool]

I would think that combo should make more power and especially more torque. can you post the dyno sheet?

[red69superbee]

i can post that but i dont have it here.it might could make more power with more compression, its actually fairly tame

[red69superbee]

you can watch the dyno run on youtube if you like..search for " 541 dodge d trent.".should go right to it

[Challenger340]

i built this engine although its not in the car yet.643 hp at 5600rpm. and 676 tq at 3700 ? i believe.10.0 compression  4.50 stroke and .055 overbore.i used edelbrock victor heads with harland sharp rockers.an MP. dominator intake with a pro systems sv-1 single barrel carb

Very Nice Engine 
and,
 with a relatively easy Camshaft, good job !

[tan top]

 

[Homerr]

https://www.youtube.com/watch?v=dvsF_LTTW9I